U.S. Customs and Border Protection, San Juan Laboratory, Thin Sectioning Instrument   3

The Office of Operation Support, Laboratory Scientific Services Directorate San Juan Laboratory (SJ LAB) needs a Thin Sectioning Instrument to be able to prepare stone samples for mineralogy, microstructure, and composition analysis. CBP is looking for any equipment that meets or exceeds the general characteristics below. However, if your equipment meets the general purpose of a thin sectioning instrument but does not meet or exceed the characteristics below, please submit a market research quote so that CBP may review its options.

Weight: < 250lbs
Dimensions: 34 * 30 * 20 in or less
Cutting wheel speed: 800 rpms or more
Grinding capability: At least three samples to be processed simultaneously
Calibration: Digital micrometer
Motor: 2 hp or more
Electrical requirements: 3-prong grounded plug, 110V 60Hz
Control:
- Digital touchscreen display
- Push-buttoned membrane switch
Safety:
- Soundproof enclosure
- Safety interlock system
- Emergency stop button
- Integrated vacuum pump with sensor
Common Samples: Stones, cement, ceramic, and ores
Accessories Required:
- Cutting fixtures
- Diamond cut off wheel 250 mm diameter with metal bond
- Grinding fixture
- Diamond grinding 175 mm diameter cup wheel
Installation:
- On-site installation.
Training:
- On-site training.
Please submit a market research, non-binding quote that can be used to determine whether this requirement may be competed via open market procedures. Shipping will be to San Juan, Puerto Rico.