CONTROL ASSEMBLY, QU, IN REPAIR/MODIFICATION OF   3

CONTACT INFORMATION|4|N733.06|N00383|2156971323|CHELSEA.J.THOMAS5.CIV@US.NAVY.MIL| WIDE AREA WORKFLOW PAYMENT INSTRUCTIONS (DEC 2018)|16|INVIOCE AND RECEIVING REPORTS (COMBO)||N/A|N00383|N/A|N/A|N/A|N/A||||||||| The total quantity of this requirement is decreased by 35; from 61 to 26. ALL TERMS AND CONDITIONS OF BOA N0038320GW601 APPLY. THIS IS A REPAIR REQUIREMENT. RTAT IS 120 DAYS. 1. SCOPE Articles to be furnished hereunder shall be repaired, tested andinspected in accordance with the terms and conditions specified in theRequirements Section of this document.Unless expressly provided for elsewhere in this clause, equipment suchasfixtures, jigs, dies, patterns, mylars, special tooling, test equipment, oranyother manufacturing aid required for the manufacture and/or testing of the subject item(s) will not be provided by the Government or any other source andis the sole responsibility of the contractor. The foregoing applies notwithstanding any reference to such equipment or the furnishing thereof thatmay be contained in any drawing or referenced specification.Contractor will provide Tear down Reports from March 2015 to September2020 for the Throttle Quadrant Assembly (P/N: 3F1209F, 3F1209G, 3F1209H). IAW with the attached 1423 CDRL 2. APPLICABLE DOCUMENTS - NOT APPLICABLE 3. REQUIREMENTS - NOT APPLICABLE 4. QUALITY ASSURANCE PROVISIONS - NOT APPLICABLE. 5. PACKAGING- MIL-STD 2073 PACKAGING APPLIES AS FOUND ELSEWHERE IN THE SCHEDULE 6. NOTES - NOT APPLICABLE DATE OF FIRST SUBMISSION=ASREQ DATE OF SUBSEQUENT SUBMISSION=ASREQ A REQUEST FOR VARIANCE IS REQUIRED FOR ANY DEVIATION OR WAIVER ENCOUNTERED DURING ANY PORTION OF MANUFACTURE. THIS MUST BE ROUTED TO THE ACO AND DCMA-OFFICE. THE FORM IS DD-1694 AND THE DCMA SHALL PROVIDE A FORM DD-1698.THE RFV MUST GO TO THE CONTRACTING OFFICER AT NAVSUP WSS FOR REVIEW AND THEN FORWARDED TO THE BASIC DESIGN ENGINEER FOR REVIEW AND DETERMINATION. DATE OF FIRST SUBMISSION=ASREQ DATE OF SUBSEQUENT SUBMISSION=ASREQ Tear down reports from 2015 to September 2020 for the Throttle Quadrant Assembly (P/N: 3F1209F, 3F1209G, 3F1209H). Block 9: Distribution authorized to the Department of Defense and U.S. DoD contractors only (Critical Technology) (30 September 2019). Other requests shall be referred to Department of the Navy, Program Executive Officer Tactical Aircraft Programs PMA-265, Program Security Manager, 47123 Buse Road B2272 RM445, Patuxent River, MD 20670-1547. Block 12: Submittal is due within 45 days of contract award. Block 14: The tear down reports from 2015 to September 2020 shall be sent to the PCO and the following government E-mail addresses. NAVAIR zakary.monin@navy.mil gregory.t.leavitt@navy.mil eric.redmond@navy.mil dan.budzenski@navy.mil robin.sluder@navy.mil konstantin.kotlyar1@navy.mil alie.kargbo@navy.mil NAVSUP theotis.williams@navy.mil